ClearSpan R035B00011A Manuel - Sayfa 7

Sera Kiti ClearSpan R035B00011A için çevrimiçi göz atın veya pdf Manuel indirin. ClearSpan R035B00011A 15 sayfaları. Greenhouse door kits

Sayfayı Yazdır

Twin-Wall Double Swinging Doors

DoubLe TWIN-WALL DooR ASSeMbLY

If your doors include corrugated polycarbonate

panels, skip this section and continue with the

assembly steps for those doors. The materials and

parts needed to assemble the R035B00011A double

door include:

•

Door frames (#102923), 8mm panels (102908), door

hinges (FA5030), end cap (104548), and latches

(FA2410)

•

Tek screws (#FA4484B), neo-bonded washers

(#102921B), and aluminum profile (#104213)

Assemble and Attach the Doors

NoTe: Install the polycarbonate panels with the

UV-protected side toward the outside/sun.

Locate one (1) door frame (#102923) and place it on

a flat surface.

Take one (1) polycarbonate panel and trim it so that

the length is one-quarter inch (1/4") shorter than the

length of the door frame.

Trim the width of the polycarbonate panel so that it is

one-quarter inch (1/4") narrower than the width of the

door frame.

NoTe: Trimming the panels as instructed will keep

the panel flush with the edge of the door frame once

the aluminum profile (104213) is installed.

Center the panel on the door frame so that

approximately one-eighth of an inch (1/8") of the

door frame extends beyond the edge of the panel.

Using Tek screws (FA4484B) and galvanized neo-

bonded washers, attach the panel to the horizontal

cross tube of the door frame. Evenly space Tek

screws and washers every 12".

NoTe: Attach the panel in the locations shown in the

photo to hold the panel in place while attaching the

aluminum profile to the perimeter of the panel. Do

NoT INSTALL NEAR LATCH MoUNTING HoLE.

Revision date: 05.28.10

Install aluminum U-channel profile to all edges of the

polycarbonate panel. The 104213 sections at the top

and bottom of the panel run to the panel edges to

seal the cells in the panel.

Photo shows the polycarbonate panel attached to

the outside of the door frame and finished with the

aluminum (104213) U-channel profile.

To keep the panel and profile in place, install Tek

screws and neo-bonded galvanized washers so the

screw drills through the longer edge of the U-channel

(underside of the polycarbonate panel) and the

washer overlaps the shorter edge of the U-channel

(top) as shown above. Evenly space Tek screws

every 12".

Repeat the above steps to attach the polycarbonate

panel and to install the aluminum profile for the

remaining door frame.

Determine which door to install the handle, locate

the door latch hole (5" from edge of door in cross

member) and drill 1" hole through the polycarbonate

panel at the hole location.

Sample

Frame

Handle