ClearStream 600DAC3 Kullanıcı El Kitabı - Sayfa 7

Endüstriyel Ekipmanlar ClearStream 600DAC3 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. ClearStream 600DAC3 12 sayfaları.

10. For below normal grade installations a Clearstream 20-inch diameter riser may be used. In no

case shall more than 18" of maximum riser depth be used on a Clearstream Unit to bring the access

covers above the final grade.

intrusion before back-fill is completed.

11. Before leaving excavation site, be sure to securely fasten the Clearstream access covers in

place with the tamper resistant screw(s).

personnel from gaining access to the inside of tank.

CLEARSTREAM AERATOR AND CONTROL PANEL

1. Mount the Clearstream Control Panel in a location that can be easily noticed by the occupants.

2. Wire 115 Volt, 60Hz power from an electrical disconnect to Clearstream Control Panel. Wire from

Control Panel to Clearstream Tank electrical junction box through conduit.

provided for each version of the Clearstream Control Panel series.

installed by a qualified technician in compliance with NFPA 70 for all electrical components, electrical

connections, and system installation.

3. Install Clearstream Aerator Model CS-103ET6, as close as practical to the tank, but in no case

greater than one hundred (100) feet away. Run 3/4" Sch. 40 PVC air line from aerator connector

to the air line connection at Clearstream tank.

manner which will not cause air line to leak.

non-dusty and highly ventilated.

COMPLIANCE WITH LAWS

The Clearstream Unit must never be installed without first obtaining all permits and approval

from the local regulatory body.

activities, all applicable State and Federal environmental codes must be adhered to as

well.

Only properly licensed and trained individuals should install Clearstream equipment. The

effluent from the system should only be utilized for disposal as described in NSF/ANSI Standard

40, 245 and 350 and as is in compliance with all local, state and federal requirements.

care should be taken when installing a unit to prevent cross connections and protect against back-

flow to potable water supplies.

All risers must be sealed with a sealant to prevent ground water

Tighten screws firmly to keep unauthorized

Be careful to backfill under-ground air line in

Aerator must be installed in a location that is dry,

In areas that do not have local control over environmental

Use wiring diagram

All electrical wiring should be

7 of 12

Special