Diy Kyoto Wattson Manuel - Sayfa 5

Ölçüm Cihazları Diy Kyoto Wattson için çevrimiçi göz atın veya pdf Manuel indirin. Diy Kyoto Wattson 13 sayfaları. Energy-saving device

Installing the sensor

and transmitter.

1 / Insert the batteries into the transmitter.

The transmitter takes 4 AA batteries. Make sure the end of the battery

marked

goes in the end of the tray marked

2 / Make sure the aerial on the transmitter is extended.

3 / Plug in the sensor lead.

There are 4 sockets on the transmitter. Plug the sensor lead into the

one marked

Warning: Do not connect to the socket marked

which is reserved for

renewable energy systems.

4 / Attach the sensor clip.

The sensor clip can be attached to either of the 2 cables running from

the electricity meter to the fusebox. If your meter is a long way from your

fusebox (as you might find in a block of flats), connect the clip to the

cable where it enters the fusebox, so that the transmitter is as near as

possible to where you will be using the wattson display. Simply undo the

clip and fit it around the cable. Make sure the clip top is firm and secure

in the clip base.

Warning: The leads running from the meter to the fusebox must be

accessible for the sensor clip to be fitted - if they are not, please

consult a qualified electrician. Further information on www.diykyoto.com

5 / Place the transmitter.

The transmitter can go on the wall next to the meter (or fusebox), or

on a nearby shelf if there is one. If your meter is in a meter box, the

transmitter may work best if it's outside of it. If the sensor lead does not

reach outside, it will work from inside the box but the range may not be

as good.

Warning: The transmitter must not be left hanging from its lead as this

puts strain on your wiring and may result in the transmitter coming loose

or falling. The transmitter must be protected from water and the elements

and must not be used outdoors - this will invalidate your warranty