DIY Retractable Awnings SunCover 4000 Kurulum Manüelleri - Sayfa 8

Aksesuarlar DIY Retractable Awnings SunCover 4000 için çevrimiçi göz atın veya pdf Kurulum Manüelleri indirin. DIY Retractable Awnings SunCover 4000 11 sayfaları.

Sayfayı Yazdır

ROOF MOUNTING

Installing On The Roof (flat shingle style only – NOT tile or slate): On the roof,

move up to the second or third row of shingles (approximately 9" to 12") from the

edge of the roof. Mark the roof with the outer ends of the awning placement.

Next carefully flip up the end of the shingles to expose the tail ends of the rafters.

If you cannot see the rafters, use a stud finder to locate them. With all of your

measurements indicated on the roof as described earlier, take the 3-holed roof

mount bracket plate, place it on the shingles and pre-drill three ¼" holes the

length of the lag screws. Remember your goal is to get into the roof rafter a min-

imum of 2 ½" while not splitting the rafter. Fill all holes and cover the back of the

roof bracket plate with caulk or roofing cement. Tighten all three lag screws and

proceed in the same fashion for the rest of the plates. Proceed to SECURING

THE AWNING IN THE BRACKETS section.

SECURING THE AWNING INTO THE BRACKETS

Once all the installation brackets are securely fastened to the wall, check again

that they are level – you don't what to find this out while you are on your ladder

with a 200 lb awning in your hands.

Like your mother always said, "wash your hands!" before proceeding. Clean

hands will not leave marks on the awning fabric and will greatly reduce clean

up time.

Take the awning out of the clear plastic covering using

a scissor and cutting away from the fabric – not a razor.

With the arms facing down and fabric roller on top, you

and your assistant(s) carefully walk the unit up the ladder and place the square torsion bar into the installation brackets. You

should use some side to side movement to help place the awning in the desired location. Once securely in the brackets, re-

install the installation bolts and fully tighten – DO NOT operate the awning until these bolts have be fully installed.

OPERATION

Motors and Controls: (optional)

Your unit has the optional motor with a weather proof, UL listed plug-in cord – either 12' or 24' based on what you se-

lected. Simply plug the cord into a GFI receptacle. The remote control, which is provided, will now operate the opening

and closing of your awning. Your awning shipped with a motor override stem in a bag - about 4" long. The crank han-

dle, also provided, The override stem is installed into the head of the motor (on the drive side) and secured with

an washer and 3mm allen wrench from the top of the motor. To manually operate your awning, place the crank han-

dle "hook" into the override stem "eye" and turn the crank handle.

WARNING! - Be sure that the unit is fully installed

with all mounting hardware and installation bolts

secured before using the remote control.

Override stem - runs through the motor

head and is secured from the top

Your hand held remote control comes

with mounting hardware