ClearView CBT Kit Kurulum Kılavuzu - Sayfa 2

DVR ClearView CBT Kit için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. ClearView CBT Kit 4 sayfaları.

Sayfayı Yazdır

CAMERA INSTALLATION

You will need the following tools for installation: An OSHA approved ladder, Phillips screwdriver, power drill &

3/4" and 3/16" bits, rubber self-seal tape or heat shrink tubing, and some caulk or sealant for outdoor cables.

A section of stiff wire and some masking tape can help run the camera cables.

TIP: When you run your camera wires, MAKE SURE that the POWER JACK

video cable is located at the DVR end to connect to one of the camera power supply plugs

there. It's a good idea to set up the system on a table or workbench before installation,

free just the ends of each cable, connect and test & familiarize yourself with connections.

•

Check local laws regarding installation & aiming of outside cameras, stay clear of AC electric wires

& fixtures, and be considerate of your neighbor's privacy. Determine your camera locations, and run

the cables to each camera. Do not point cameras directly into light sources, or directly into the rising

or setting sun which may cause damage to the camera's sensors that will not be covered under

warranty. IMPORTANT: Make sure that the cable at the camera ends with the power plug

so that it will correctly attach to the camera's power lead. The BNC plug

both cable ends.

•

Use the included base mounting templates to mark the mounting screw

NOT CUT CAMERA WIRES - this will void warranty. If the connections are exposed to weather,

seal with heat shrink tubing or self-adhesive sealing tape, then finish mounting the camera bases

and caulk/seal any outside holes.

DVR INSTALLATION

holes. Pre-drill the screw anchor holes with the 3/16" bit,

and drill the cable access holes with the 3/4" bit. Loosely

attach each camera in position with one or 2 screws, attach

each camera's BNC video and power leads to the cable,

and fish the camera wire through to the DVR location. DO

will be the same on

Place the DVR and monitor within reach

of the provided 60 foot camera cables

and a wall plug AC power source (a

battery backup UPS is recommended). If

you are attaching a monitor using the

HDMI output, remember to locate the

unit so that is within reach of the HDMI

input on your TV or AV receiver. At the

DVR, attach the DVR power supply,

your VGA monitor & power supply, and

camera power supply to AC power, and

each camera cable's power plug

to one of the 4 power jacks

on the camera power supply.

On the back of the DVR (or on the multi-

input cable on the touch screen CBT

DVR), push in and twist-lock the BNC

plug

connector for each camera

to the chosen channel's BNC input,

attach the USB mouse, power on &

begin DVR setup.

end of the