DIYElectronics PRUSA I3 Oluşturma Kılavuzu - Sayfa 4

3D Yazıcılar DIYElectronics PRUSA I3 için çevrimiçi göz atın veya pdf Oluşturma Kılavuzu indirin. DIYElectronics PRUSA I3 19 sayfaları.

[1] Preparing Your Printer

Before you get started with building the enclosure, there are a few

preparation steps to be done in order to get your Prusa i3 printer neat,

calibrated and ready to be placed within the enclosure.

[1.1] Wiring

Cable management is

extremelyimportant so that

cables dont get in the way

and get damaged or broken

• Make sure cables are neat

and tidy with use of cable

wrap and cable ties

*Especially around the

RAMPS board

See photo examples of neat

cable management

[1.2] Calibration

• Run a calibration test print on

your printer to ensure your

printer is well calibrated and

running smoothly before you

place it in your built enclosure

Make sure everything on your printer is neat, tightened, adjusted

and calibrated before you put your printer into the enclosure.

This is to avoid issues and to ensure everything will run smoothly.

You may cable tie this up once the printer is in the enclosure so that

it does not interfere with the bed moving back and forth when printing