ClearWater CW13 Kurulum Talimatları - Sayfa 2
Sıhhi Tesisat Ürünleri ClearWater CW13 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. ClearWater CW13 2 sayfaları. Overflow bath waste
Ayrıca ClearWater CW13 için: Kurulum Talimatları (2 sayfalar)
Sayfayı Yazdır
Installation notes
• Ensure the air vent is installed at the top of the waste outlet as shown below.
• If temperatures fall below 0 C protect from frost.
• Only use potable mains water, and in particular avoid salt water or water containing contaminants
such as sand or grit.
• Any alterations or modifications to the product will void the warranty
• Do not use any cleaning products containing solvents, acid or alkaline corrosive substances.
• Abrasive sponges or metallic scouring pads should not be used as these could damage the
treated surfaces.
• A small amount of water may continue to drain from the waste during the opening and closing
process when the water level is below the 25cm depth.
• Any use which fails to comply with the installation notes will void the manufacturer's warranty and
liability.
94°
Ø85
Ø75
Ø49
Ø66
80
45°
NB:
make sure the air-vent is
positioned at 45 degrees maximum
129
NB: Air vent must be positioned as shown
above.
+
25cm
-
1 cm
+
40cm
-
1 cm
+
25cm
1 cm
-
3° max
STARTS TO OPEN
At a depth of 25 cm the Smartwaste gradually starts to
open, until the waste fully opens above a depth of 36 cm.
FULLY OPEN
Outlet
max 30 l/min
FULLY CLOSED
The drain is fully open when the water level is above 36
cm. The Smartwaste will automatically close when the
water level drops below 25cm.
Inlet
max 28 l/min