Altrason Humidry BRA-200V Kurulum Kılavuzu - Sayfa 2

Nem Alıcı Altrason Humidry BRA-200V için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Altrason Humidry BRA-200V 13 sayfaları. Ceiling mounted desiccant rotor multifunctional dehumidifier

Sayfayı Yazdır

The following symbols are used to indicate the level of danger resulting from incorrect use.

WARNING

result in death or serious injury.

Safety Precautions

・

Please find a reseller or specialized technician for

installation as installation and electrical work require

specific expertise.

・

Carrying out your own installation may result in water

leakage, electric shock, or fire.

・

Power outlets must be properly grounded.

・

An Earth Leakage Circuit Breaker (or GFCI in the US) must be

installed for installation in bathrooms and other wet areas.

・

Please install dedicated Earth Leakage Circuit Breaker

where it is easily accessible. Make sure that the power

supply is appropriate and corresponds with your unit's

need： BRA and BRB series with corresponding voltage at

200V, 220V, 230V, or 240V, no less than 15A of current load.

BRC series with corresponding voltage at 100V, 110V or

120V, no less than 20A of current load.

・

BRF series with corresponding voltage at 100V, 110V, 120V,

200V, 220V, 230V, or 240V, no less than 10A of current load.

BIF series with corresponding voltage at 100V, 110V, 120V,

200V, 220V, 230V, or 240V, no less than 10A of current load.

・

Use of incorrect power supply may result in fire or electric

shock.

・

During installation and maintenance, please ensure that

power is turned off and check power supply.

・

Operation of the unit is prohibited during interior decoration

work at the site. The unit should be protected from dust and

dirt.

・

To prevent poor operating efficiency, please ensure that the

site has been thoroughly cleaned, floating particles and

airborne odors have been removed, and the unit is clean

prior to operation of the Unit.

・

Please ensure that all components are properly installed.

Unsecured components may result in injury.

・

Please wear gloves during installation to prevent injuries.

・

Do not install in areas where organic solvents and sprays

are used.

・

Do not disassemble, repair, modify, or reinstall the unit.

Incomplete or inaccurate assembly and installation can

cause fires, electrocution or unit malfunction. Unsecured

components may fall and cause injuries.

Safety Instructions

Please read this guide carefully prior to installation.

Incorrect use may

CAUTION

result in injury or property damage.

・

Please do not use extension cords of any kind as this

may cause overheating, risk of fire and electrocution.

・

Do not use damaged or refurbished power cord. Do

not place anything heavy on the power cord or alter

the power cord in any way, as this may cause damage

to the cord.

Installation Cautions

・

Install the unit in the center of the bathroom. Do not

install the unit directly above showers or bath tubs to

avoid excess steam from getting into the unit.

・

The unit requires a 450x350mm (17.75"x13.75")

opening for installation. Please also reserve

maintenance panels.

・

Please take into consideration of the weight of the unit

(7.2 kg or 15.8 lbs) during installation so that it is

installed in a safe manner.

・

Please use 10cm (4") air ducts and sealed with tape to

the unit.

Moving and Repair

Cautions and Warnings

・

Turn off power before inspecting the unit.

・

Should an anomaly occur, please stop operation of the

unit, and then turn off power. Continued operation

during an anomaly may result in malfunction, electric

shock, or fire.

・

When re-installing the unit after it has been moved,

please follow the installation steps. When re-installing

the unit, improper installation may result in electric

shock or fire.

・

To avoid danger, unit operation should be stopped

immediately if the power cord is found damaged.

Please contact your dealer.

Incorrect use may