ClearWater AQUA ELITE 50 Kurulum ve Bakım Kılavuzu - Sayfa 15

Aydınlatma Ekipmanları ClearWater AQUA ELITE 50 için çevrimiçi göz atın veya pdf Kurulum ve Bakım Kılavuzu indirin. ClearWater AQUA ELITE 50 20 sayfaları.

Sayfayı Yazdır

The ozone UV bulb will need replacing after approximately 9,000 hours of use. A unique feature of the AE-50 is

that the unit comes with an exclusive "Change Bulb" indicator. When this light is on, it will be time to replace the

bulb. Order the replacement bulb noted above from your dealer. The replacement bulb will come with complete

instructions on how to change it. A condensed version is noted below:

When replacing the UV bulb, we strongly recommend you remove the unit from the wall. This is to ensure

you carefully remove the delicate equipment from the metal enclosure properly, and seal back up tightly.

Bottom of unit with

bottom panel off

Replacing the bulb in the Aqua Elite 50 unit.

1. Disconnect power from the Aqua Elite 50 unit. Coming into contact of the exposed ozone bulb can cause serious

damage to your health.

2. Remove the six (6) screws on the bottom of the unit.

3. Carefully pull off the bottom panel and slide out the 1 metal plate with the UV bulb and ballast attached to it as far as it

will go – approximately 11 inches. There is a tether holding it in place so it will not completely disconnect from the

AE-50 box. Be careful NOT to pull out any wires.

4. Cut the zip tie holding the bulb in the bulb clamp. Be careful NOT to break the bulb.

5. Carefully pull the bulb from the white connectors and the bulb clamp from holding them in place and remove. Be

careful NOT to break the bulb. Dispose of bulb properly after removal.

6. Snap new bulb in place. Secure with the metal brackets.

7. Push metal plate back into its place inside the unit. There is no need to add another zip tie as this was used for shipping

purposes.

8. Replace the bottom panel, making sure the gasket is seated in the groves properly.

9. Tighten the 6 screws back into place, securing the bottom plate tightly.

10. Reconnect power. Make sure the bulb indicator (the clear connector on the output tube of the power box) glows in a

blue color. Again, you may want to check this in the evening hours out of direct sunlight.

11. To reset the "Change Bulb" indicator light, you will need to push the two buttons (labeled "up" and "down") at the

same time and hold for about 10 seconds. The "Change Bulb" LED light should go off at that point and be

recalibrated for the new UV bulb.

Replacing the UV Bulb

Order replacement part – OZ-50/75L –

Replacement Aqua Elite 50 bulb – from your dealer.

R). REPLACING THE UV BULB

Metal plate with the bulb

ballast attached to it

Zip tie holding in bulb

Carefully remove bulb from

metal bracket & white connector

Cut zip tie

holding in bulb

Carefully replace bulb in white

connector and metal bracket