ClearWater Emperor Kurulum Talimatları
Küvetler ClearWater Emperor için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. ClearWater Emperor 2 sayfaları.
. CAUTION: Risk of product damage.
•
It is advisable always to run in some cold water before turning
on the hot tap
•
Do not use abrasive cleaners.
•
Wipe your bath with a soft cloth after each use to prevent a
build-up of soap and residue.
•
Avoid cleaning products that contain acetone, ethyl alcohol,
amyl or ethyl acetate, sodium
hypochlorite, toluene, or phenol. These products can damage
the finish
•
Extreme heat such as that generated by cigarettes or portable
heaters can damage Acrylic surfaces. Do not use such items
near your bath.
•
In the event of slight scratches in the bath surface, a mild
abrasive, similar to metal polish, can be used to polish these
out.
FOR TECHNICAL ADVICE/ SPARE PARTS
PLEASE CONTACT OUR CUSTOMER
SERVICES DEPARTMENT
Tel. 01274 738140 Fax. 01274 732461
TO THE INSTALLER
Please leave the instruction leaflet for the
customer
Clearwater Collection Ltd
Enterprise House, Ironworks Park
Bowling Back Lane, Bradford
BD4 8SX
The Emperor Bath
Installation Instructions
Please read carefully prior to commencing any work.
Any installation should only be carried out by a qualified tradesman with knowledge of the
Statutory Regulations and plumbing requirements for your area.
HANDLING
Please note that this product has been through our rigid quality control procedures which
include a thorough visual inspection under bright lights water testing etc. Please unwrap the
bath and check it carefully to ensure it has not been damaged in handling or transport which
is beyond our control.
Do not remove the old fixture before you unpack and inspect the new unit.
Upon receipt, check for shortages. Report any shortages immediately.
Store the bath and wall surrounds in a safe place until you begin installation to avoid
damage.
Claims regarding cracks and/or face damage must be reported
within 24 hours of receipt of the product. No such claims will be
recognised after installation as this is classed as acceptance of the
product.
The bath should not be exposed to direct flame or abnormal heat. Once installed it is good
practice to cover the entire bath with a soft protective cloth until other trades have completed
their work.