ClearWater Lights Darla Kurulum Kılavuzu - Sayfa 14
Motosiklet Aksesuarları ClearWater Lights Darla için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. ClearWater Lights Darla 16 sayfaları. Led light kit for bmw k1600gt
Ayrıca ClearWater Lights Darla için: Kurulum Kılavuzu (12 sayfalar), Kurulum Kılavuzu (12 sayfalar), Kurulum Kılavuzu (12 sayfalar), Kurulum Kılavuzu (12 sayfalar)
Sayfayı Yazdır
Clearwater CANopener operation and features
HORN ACTIVATION MODE
The Clearwater lights can be programmed for three different modes when
the horn button is pressed. Toggle these modes by holding the brake lever
and pressing the Turn Signal Cancel button three times. The brake and
Clearwater lights flash to indicate the mode selected:
•
Mode 1 – horn does not affect lights (default)
•
Mode 2 – horn activates lights 100%
•
Mode 3 – horn strobes lights (if two sets of Clearwater lights are
installed, they will alternate flashing)
WARNING:
The use of strobe mode may not be legal on public highways.
Check your local regulations. This mode is intended for parades and
escorts under certain conditions.
HAZARD FLASHER ALERT MODE
The Clearwater lights can be programmed to strobe when the hazard
flasher button on the left grip is held down. Toggle these modes by holding
down the hazard flasher button and pressing the brake lever three times:
•
Mode 1 – OFF, no flash with emergency flasher button (default)
•
Mode 2 – strobe with emergency flasher button held down (if two sets
of Clearwater lights are installed, they will alternate flashing)
NOTE:
Pressing the hazard flasher button activates the turn signal flashers.
Cancel the flashers with another short press of the button.
WARNING:
The use of strobe mode may not be legal on public highways.
Check your local regulations. This mode is intended for parades and
escorts under certain conditions.
HIGH BEAM MODE
The Erica/Krista lights can be programmed for two modes of
operation in conjunction with high beams. Toggle these modes by holding
the brake lever and pressing flash-to-pass three times:
•
Mode 1 – all Clearwater lights turn on 100% when high beam or flash-
to-pass is pressed. Erica/Krista use the day/night dimmed setting on
low beam. Erica/Krista lights must be turned on. (default on ver 1.5 or
greater)
•
Mode 2 – HIGH BEAM ACTIVATION. All Clearwater lights turn on
100% when high beam or flash-to-pass is pressed. Erica/Krista are
turned off with low beam. Erica/Kristas do NOT need to be turned on.
(default on ver 1.6 or greater)
Page 14