Clearwater Spas CLEAR A-400 Kullanıcı Kılavuzu - Sayfa 3

Spa Aksesuarları Clearwater Spas CLEAR A-400 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Clearwater Spas CLEAR A-400 20 sayfaları.

1. Ensure hardness, pH, alkalinity and TDS are within acceptable levels

(see Maintenance section in operating manual for details).

2. Excessive amounts of algae or bacteria must be controlled prior to

installation.

3. Run the pump a minimum of 4 hours per day.

4. A residual of chlorine or bromine or alternative non-toxic oxidizer

should be maintained to break down organics (sweat, hair, urine,

make-up, sunscreen, etc.)

5. Keep your ion level between 0.2ppm – 0.6ppm. Test your water

with the Copper Test Kit periodically to ensure ion level is within this

range. Do not reduce the amount of sanitizer used until the ion

level reaches 0.2ppm.

6. Shock may be required in cases of extreme weather conditions or

increased bather loads resulting in high contaminants.

7. Do not plug the controller into a timer. It

should always have power.

8. Install electrodes parallel to the water flow

and ensure the tee is always full of water.

AT T E N T I O N

CLEAR | State of the Art Water Management | 3