DJ Techtools Midi Fighter 64 Kullanıcı Kılavuzu - Sayfa 6

Kayıt Ekipmanları DJ Techtools Midi Fighter 64 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DJ Techtools Midi Fighter 64 16 sayfaları.

Sayfayı Yazdır
Banks Modes
The Midi Fighter 64 defaults to banked mode. In this mode the 64 arcade buttons send different
notes depending on which bank is currently selected. All arcade button notes are sent on
channel 3 for Bank 1 and channel 2 for Bank 2. All other messages are sent on channels 4 - 6.
The bank selection can be changed by holding the top right button for 2 seconds to access
Bank 2 or the top left button to return to Bank 1. This allows you to still use those buttons for
sweeps or risers that ease transitions between Sound Packs. Colors can be set individually the
buttons on each bank via the MF Utility so it's easier to tell them apart. Banks buttons also send
midi signal as detailed in the Advanced Bank Control section below.
Corner Button Bank Change
If you do not wish to use banks when creating your own midi mapping you can set the "Corner
Button Bank Change" setting to "Disabled" using the Midi Fighter Utility software. When this
mode is disabled the arcade buttons will send the MIDI data specific to Bank 1
Hold
In this mode the bank buttons behave like any normal button, sending a note on when held,
and a note off when released. By holding the top left or right buttons for 2 seconds you can
navigate between the virtual banks available in your device.
Press
Similar to Hold but removes the 2 second delay, making bank changes happen instantly.
Disabled
Disables bank functionality altogether and MIDI notes sent by the arcade buttons are sent
on channel 3, matching the first bank layout.
Advanced Bank Control
It is also possible to use MIDI to read and set the currently selected bank.
When the virtual bank selection changes the Midi Fighter 64 sends an updated CC value to
indicate a new bank has been selected. By default the bank selection notes are sent on MIDI
Channel 3.
I.e. When changing from Bank 1 to Bank 2 the Midi Fighter will send a Ch3 CC03 with velocity
of value 1.
By using MIDI Out on your software of choice and sending a CC message to the MIDI Fighter
64 it is also possible to force it to automatically change to a specific bank.
Bank Change CC
Bank 1 | Ch.3 CC 03 Velocity 0
Bank 2 | Ch.3 CC 03 Velocity 1-127

! 6