Edic ENDEAVOR Hızlı Kılavuzlar - Sayfa 10

Ultrasonik Mücevher Temizleyici Edic ENDEAVOR için çevrimiçi göz atın veya pdf Hızlı Kılavuzlar indirin. Edic ENDEAVOR 15 sayfaları. Multi-purpose extractor
Ayrıca Edic ENDEAVOR için: Kullanıcı/İşletmeci El Kitabı (17 sayfalar)

Sayfayı Yazdır

VACUUM:

Before Using the Vacuum, first connect your vacuum hose to the hose barb connector on the machine as well as your

floor tool (carpet wand, REVOLUTION, upholstery tool). Then turn on the vacuum motor by placing the vacuum (VAC)

switch, located on the front panel, in the ON position.

PUMP:

Before turning on the pump, make sure your solution line and working tool are connected to allow spraying. To turn the

ENDEAVOR's pump on, locate the pump switch on the front panel and place it in the ON position. If your pump needs to

be primed, please see priming and pressure relief section. Never leave the machine unattended in the "P" position to

prevent flooding or loss of solution.

REGULATING PRESSURE:

To regulate pressure, locate the regulator on the front of the machine and turn the pump switch into the on position. Turn

the regulator counter-clockwise to reduce pressure and turn clockwise to increase pressure.

Do not regulate above 1100PSI. Do not regulate while spraying.

Make sure you have set the pressure appropriate for the particular job you are

performing.