Edic COMET Kullanıcı/İşletmeci El Kitabı - Sayfa 3
Yıkayıcı Edic COMET için çevrimiçi göz atın veya pdf Kullanıcı/İşletmeci El Kitabı indirin. Edic COMET 13 sayfaları. 3 gallon self-contained extractor
Sayfayı Yazdır
GROUNDING INSTRUCTIONS:
This piece of equipment must be grounded. Should an
electrical malfunction occur, grounding provides a path
of least resistance for electrical current- reducing the risk
of electric shock. This piece of equipment is furnished
with a cord that has a grounding conductor and ground-
ing plug. The grounded plug must only be plugged
into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordi-
nances.
WARNING:
Connecting the equipment to an improperly grounded
outlet can result in an increased risk of electric shock. A
qualified electrician should be consulted if you are un-
sure that the outlet is properly grounded. Do not modify
the plug provided with the equipment. If it will not fit
the outlet, have a proper outlet installed by a qualified
electrician.
This appliance is designed for use on a 120-volt circuit.
The grounding plug provided looks like the plug illus-
trated in Figure 1. Replace the power cord if the ground-
ing pin is damaged or broken.
Extension cords connected to this machine should be
12 gauge, three-wire cords with three-prong plugs and
outlets. DO NOT use extension cords more than 25 feet
(7.6 m) long.
Fig. 1
DAILY MAINTENANCE:
The COMET is engineered and built to require mini-
mum maintenance. But like any machine, it does require
some care to keep it in optimum working condition.
Careful attention to these maintenance instructions
will give you maximum operating performance and life
expectancy of the machine.
CAUTION: Disconnect the power cord from the out-
let before doing any clean up or maintenance on the
machine
1. Keep the machine clean, inside and out including the
lid, bucket, brush and brush chamber.
2. Pour a gallon of clean hot water in the smaller open-
ing of the bucket. Tum the pump on and flush the
entire system through the spray nozzles for about a
minute to prevent alkaline build-up.
3. Keep filters clean.
4. Quick connect coupler- Spray with silicone lubricant
to keep coupler from sticking.
5. Valve, upholstery tool- If the plunger on the valve
sticks, spray with silicone lubricant.
Servicing:
In the event that your heater requires service, please
contact EDIC at:
800-338-3342
or email [email protected]
Do not attempt repairs yourself. EDIC will assist you in
locating an indepedent service contractor.
3