Altron ACC2HD Kullanım Talimatları - Sayfa 4
Endüstriyel Ekipmanlar Altron ACC2HD için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. Altron ACC2HD 4 sayfaları. Tilt-down column
Winch - general operation notes
1. Never operate the winch by any other means than with the winch handle. THE WINCH MUST NOT
BE OPERATED WITH A POWER TOOL
2. Ensure that ratchet engages on each operation (clicking noise will be heard when winding cable on
to drum)
3. Never allow oil or grease to come into contact with the friction brake discs.
4. Ensure cable is wound tightly onto drum before operation.
5. Ensure winch is properly maintained - refer to guidance below.
6. Ensure operation as per Altron operating procedure
7. Ensure a minimum of 3 turns of cable on the winch drum before winch takes load.
8. IF IN DOUBT ASK (Call Altron technical on +44 (0) 1269 831431 or e-mail
Winch inspection and maintenance
Carry out the following checks and maintenance at least annually.
1. WARNING! Do not lubricate friction (braking)
discs. This can cause slipping or failure.
2. Apply a drop or two of #30 weight engine oil
to each bushing I.D. and to the ratchet pawl
pivot points. Maintain a thin layer of chassis
grease on the gear teeth.
3. Check for wear on the gear teeth on the winch drum or gear on the primary shaft. If excessive
replace winch. Check load being applied to winch as overloading will cause excessive wear.
4. Clean debris off winch and ensure grit and debris is cleared from gears
5. Check for any damage that has taken place i.e. denting or distortion on the winch drum or winch
casing – if present then replace winch.
6. Inspect the winch cable for fraying, kinks or flattening along its full length. If the winch cable is
frayed, flattened or kinked; replace. Investigate why fraying or flattening has occurred.
7. Check the friction (braking) discs for wear. If less than 1.5 mm thick, cracked or broken, replace
immediately.
8. During winch use, check for proper ratchet pawl operation as follows. When cranking cable in, a
ratchet clicking sound should be heard. When cranking cable out, there is no clicking and the
ratchet pawl must be fully engaged into the gear teeth. If this does not take place, then stop using
the winch and contact Altron.
Altron communications Equipment Ltd.
www.altron.co.uk
tel. +44 (0) 1269 831431