dji 3WWDSZ-10016 Hızlı Başlangıç Kılavuzu - Sayfa 11
Dronlar dji 3WWDSZ-10016 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. dji 3WWDSZ-10016 12 sayfaları.
AC Power Adapter
Model
Voltage
Rated Power
FCC ComplianceNotice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received,including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate thereceiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
Aircraft complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to
avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna
shall not be less than 20cm during normal operation.
For Remote Controller (model GL300N),SAR tests are conducted using standard operating positions accepted
by the FCC with the device transmitting at its highest certified power level in all tested frequency bands,
although the SAR is determined at the highest certified power level, the actual SAR level of the device while
operating can be well below the maximum value. Before a new model is a available for sale to the public, it
must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, Tests
for each product are performed in positions and locations as required by the FCC.
A14-057N1A
17.4 V
57 W