dji AGRAS MG-1 Hızlı Başlangıç Kılavuzu - Sayfa 13

Dronlar dji AGRAS MG-1 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. dji AGRAS MG-1 19 sayfaları.
Ayrıca dji AGRAS MG-1 için: Kullanıcı Kılavuzu (3 sayfalar)

Sayfayı Yazdır

Flight

Ensure the Flight Mode Switch is in the "P" position and wait for a strong GPS signal. Ensure the Operation Mode

Switch is in the "M" position, or else the motors cannot be started.

Takeoff

Perform the Combination Stick Command (CSC) and then slowly push the throttle stick up to takeoff.

Landing

To land, pull down on the throttle stick down to descend until the aircraft touches the ground. There are two

methods to stop the motors.

1. When the aircraft has landed, push the throttle stick down, then perform the CSC command to stop the

motors. Release both sticks once the motors have stopped.

Throttle Stick

2. When the aircraft has landed, push the throttle down and hold. The motors will stop after 3 seconds. (In M-mode,

when "M" is set as Manual mode in the PC Assistant, use method 1 to stop the motors.)

Take off immediately after the motors are spinning, or else the aircraft may drift and injure nearby people.

Rotating propellers can be dangerous. DO NOT start the motors in narrow spaces or when there are people nearby.

Always keep your hands on the remote controller when the motors are spinning.

Never stop the motors mid-flight unless in emergency situations when doing so can reduce the risk of damage or injury.

After landing, power off the aircraft before turning off the remote controller. Disconnect the cable from the XT90 port and

then the battery communication port.

Throttle Stick

AGRAS MG-1

Quick Start Guide

Throttle Stick