FiTech 50020 Talimatlar Kılavuzu - Sayfa 4

Su Pompası FiTech 50020 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. FiTech 50020 6 sayfaları. Go fuel in-tank retrofit kit

Installing C Ring

1. Place and center C-Ring on top

of recently cut hole. Use the C-

ring as a template, to mark the

(12) 9/32" holes in the tank. Set

C-ring aside, drill and deburr the

holes. (Figure 3)

2. Thoroughly clean the tank to

remove all of the metal chips and

debris inside and outside of the

tank. Prior to final installation, it is

important that the inside of the

tank is totally clean.

3. Screw the 2 threaded rods into

two holes opposite of each other

on the C-ring. Slide the C-Ring

into the 4 1/2" diameter hole

(Figure 4 & 5) inserting the

threaded rods back up through

the drilled holes. Then install the

Foam Gasket

(Item 3) as shown in Figure 6.

See Figure 20 on page 9 for

proper assembly of these parts.

Figure 5

5. Snap the Filter Sock (Item #14) onto the end of the Fuel Pump.

Figure 3

Figure 4

Figure 6