Arthrex Synergy Resection Hızlı Başlangıç Kılavuzu

Anahtar Arthrex Synergy Resection için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Arthrex Synergy Resection 2 sayfaları. Wireless footswitch

Sayfayı Yazdır

Synergy

Unpacking

Carefully unpack and inspect all components for shipping damage. Save the packaging for later transport of

the device.

The Synergy

Wireless Footswitch user's manual, shaver handpiece, Synergy

Resection

CoolCut™ shaver and burr DFU should be read prior to using these devices. The user manual and DFU provide

the indications and contraindications for use, warnings, symbol definitions, and the full list of product

instructions. These documents can be found on Arthrex.com.

Setup

Power ON console.

Fully connect receiver...

Insert 2 AA alkaline batteries into the footswitch,

(+ side first, so that the - side is facing the end cap).

Then screw on the compartment cover end cap.

Battery indicator light will

When the red flashing light disappears, the

rapidly flash

red

during

footswitch is paired. Note: The footswitch must

pairing phase (can take

be laid flat on the ground to function. If pairing is

up to 11 seconds).

unsuccessful, repeat the previous steps and ensure

that the batteries have sufficient power.

Resection™

...to footswitch port on

console.

Pairing button - Pair footswitch by simultaneously pressing the receiver and footswitch

pairing buttons, then release (footswitch must be within 6 feet of the receiver during

this process). Note: The footswitch must be held vertically so that the handle is fac-

ing the ceiling when pressing the pairing button.

Wireless Footswitch

Placement is shown above.

Quick Start Guide

Console, and each

Resection