dji E1200 Standart Kullanıcı Kılavuzu - Sayfa 5

Dronlar dji E1200 Standart için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. dji E1200 Standart 9 sayfaları.

5. Assembling the Propellers

The propeller cover mounting screws (M3×8) should be adjusted using an

appropriate hex key.

1) The propellers marked CW should be mounted to the clockwise rotating

motors, which have a

mounted to the counter-clockwise rotating motors, which have a

2) Use two propeller cover mounting screws (M3x8) to mount and secure

the propellers. First line up and apply thread locker into the thread of the

propeller mount, then tighten the screws.

CW or CCW Mark

Loose screws cannot be securely locked in place with thread locker.

6. ESC Port Description

There are two ports on every ESC. They are

Data/ESC Firmware Update Port. These ports will be clearly marked on the ESC.

Ensure that the ESC firmware is up to date and is compatible with the

motor you will install. Refer to the tag on the back of the ESC to see the

default version of the firmware.

Mount the outer ESC LED Indicators according to your needs.

The Data/ESC Firmware Update Port is used to update

the ESC firmware and adjust the ESC. To do this, visit the

official DJI website to download the DJI ESC Assistant.

http://www.dji.com/product/e1200-standard/download

7. Using the DJI ESC Assistant

The DJI ESC Assistant is used to upgrade the ESC's firmware, configure the

propulsion system, etc.

An Updater is required and is not included with the E1200 Standard.

To use the DJI ESC Assistant, connect the ESC to a computer through

the Updater, as shown below.

mark. The propellers marked CCW should be

the Outer ESC LED Port and

mark.

Screws for Propeller

Cover (M3×8)

Clockwise

Counter-clockwise

the