dji MATRICE 300 RTK Bakım Kılavuzu - Sayfa 7

Dronlar dji MATRICE 300 RTK için çevrimiçi göz atın veya pdf Bakım Kılavuzu indirin. dji MATRICE 300 RTK 19 sayfaları. Dual gimbal connector
Ayrıca dji MATRICE 300 RTK için: Ürün Bilgileri (17 sayfalar), Bakım Kılavuzu (19 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Hızlı Başlangıç Kılavuzu (10 sayfalar), Ürün Bilgileri (10 sayfalar)

dji MATRICE 300 RTK Bakım Kılavuzu
1. All batteries, including Intelligent Flight Batteries and remote controller batteries,
are fully charged.
2. It is recommended to charge and discharge the battery by following the
standard instructions before flight if the battery is stored for a period longer than
Battery
one month.
3. The Intelligent Flight Batteries are firmly installed.
4. Check the battery level and voltage of each battery cell in the battery page in the
app to make sure they are normal.
1. The Failsafe action of the aircraft is what fits your mission needs. For example,
the aircraft will land as a failsafe within in 50 m of the Home Point, and it will
Flight
hover as a failsafe when it is within in 200 m from the Home Point.
Parameters
2. The flight mode switch is set up correctly.
Configuration
3. RTH altitude, height limits, distance limits, and obstacle sensing function are set
up correctly.
Module Auto-
1. View the module auto-check information on top of the screen in the app to check
Check
if there is any error prompt.
1. There are at least 7 satellites and the aircraft works in P-mode.
GNSS
2. Enable RTK function, select the correct base station and channel, and make
Positioning
sure that RTK positioning is in use. Check in the RTK page if the heading and
positioning are fixed.
1. Data on each IMU is shown in the app. IMU calibration can be performed
successfully.
2. Data on each compass is shown in the app. The heading of the compass
Sensors
matches the physical one, and the needle is stable.
3. Compass calibration can be performed successfully.
4. The Vision System in all directions are enabled and there is no error prompt.
Top and
1. Touch the shell of the cooling fans or listen carefully to check if the cooling fans
Bottom
work normally without noise.
Cooling Fans
1. Connect the remote controller to the internet, then launch the app. Make sure that
the app and the firmware versions of the aircraft, remote controller, payloads,
Firmware
and batteries match. Otherwise, the aircraft cannot take off or there may be risks.
Consistency
2. Insert all Intelligent Flight Batteries into the aircraft to make sure that all of their
firmware versions are up to date.
Link the remote controller and aircraft, make sure the FPV camera display in the
app works normally, and then perform Combination Stick Command (CSC) to start
the motors in a safe indoor area to make the motors spin at an idle speed. Then test
the following. NOTE: Stay away from the spinning motors and propellers to avoid
Motor Spin
injuries during the test.
1. The motors start without noise. There is no error prompt in the app.
2. At the beginning when the motors start or the end when the motors stop, observe
the motors to make sure that motors 1 and 3 rotate counter-clockwise while
motors 2 and 4 rotate clockwise.
MATRICE 300 RTK Maintenance Manual
©
2020 DJI All Rights Reserved.
7