Arthur Grillo DS200 Kurulum ve Kullanım Kılavuzu - Sayfa 15

Aksesuarlar Arthur Grillo DS200 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Arthur Grillo DS200 16 sayfaları. Differential pressure sensor

Arthur Grillo DS200 Kurulum ve Kullanım Kılavuzu

10. Specifications

Overpressure
protection:
Static pressure:
Zero point calibration:
Response time:
Operating mode:
Measuring medium:
Measuring principle:
Measuring unit:
Measuring range:
Range selection:
Characteristic:
Damping:
Ambient temperature:
Storage temperature:
Setpoint settings:
signal / alarm output:
Alarm delay time:
Switching logic:
Contact Logic:
Housing:
Dimensions:
Weight:
Protection class:
Display:
Electrical connections:
Pressure connections:
Operational position:
Power supply:
Power consumption:
Output:
0,2 bar
max. 0,2 bar
adjustable by REEDcontact, no cyclic zero-point calibration
required
direct
measuring mode
air or non-aggressive gases
electromechanical diaphragm measuring system
Pa / InH20 or m3/h or cfm
DS200-P2: 0...200 Pa, 0...150 Pa, 0...100 Pa, 0...50
DS200-P10: 0...1000 Pa, 0...500 Pa, 0...300 Pa, 0...200 Pa
DS200-P60: 0...6000 Pa, 0...4000 Pa, 0...3000 Pa, 0...2000 Pa
by software menu
linear or radiated selectable by software menu
adjustable in 3 steps
-10...+50 °C
-25...+60 °C
1 limit can be set via software menu
open collector, max 30 V / 30 mA
freely adjustable in the range of
0 ... 60 seconds - 2 ... 15 minutes
MIN or MAX
active high or active low
UL 94 HB; Ultramid with hinged lid of ABS
95 x 70 x 54 mm (w x h x d)
approx. 250 g
IP 54 according EN 60529
two-line alphanumeric LCD display, 2 x 16 characters
cable entry M16x1.5, screw terminals, electronics protected
against incorrect polarity
hose connections 5 mm ø and 6 mm ø
vertical, position dependence when rotated through 90°
approx. 25 Pa
17...30 Vdc or 24 Vac ± 15 %
approx. 6 mA @ 17 Vdc and 0...10 V output
approx. 19 mA @ 30 Vdc and 0...10 V output
0/2...10 V(Imax = 10 mA @ 20 Vdc, Imax = 17 mA @ 30 Vdc) /
0/4...20 mA, max load 200 Ω
Doc.-no.: DS200_01_EN
Issue: 05/2017
SPECIFICATIONS
15