ARTHUR HOLM DB2Twin Montaj Talimatları - Sayfa 14

Monitör ARTHUR HOLM DB2Twin için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. ARTHUR HOLM DB2Twin 16 sayfaları.

ARTHUR HOLM DB2Twin Montaj Talimatları
OPTION 3
- Veneer material can't be conductor.
1. Check if the Veneer fits perfectly with the monitor. To join both parts correctly it is important that the two surfaces
are touching each other in the whole length. If there is a gap between the Veneer and the monitor, check if the hole
depth in the Veneer is correct. (To make easier the adjustment the hight of the copper cylinder can be barely
adjusted.)
2. Clean the top surface of the metal monitor housing and the
bottom surface of the Veneer.
3. Glue the Veneer. Double-side tape or glue can be used
(depending on the kind of materials are going to be jointed).
Double-side tape or glue used can't be thicker than 0,2-
0,25mm [0.008-0.01]
Veneer Guide (Optional)
The pressure applied
must not exceed 1 Kg
evenly distributed on
monitor surface.
14