ARTHUR HOLM Dynamic DB2 Montaj Kılavuzu - Sayfa 2

Monitör ARTHUR HOLM Dynamic DB2 için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. ARTHUR HOLM Dynamic DB2 13 sayfaları.

INTRODUCTION

The DB2 monitor is prepared to be mounted from below the table.

Included in this version are all necessary brackets.

PATTERN HOLE

Pattern hole dimensions for milling are specified in the corresponding drawing.

The milling of the furniture has to be done from bellow.

ATTENTION

Manipulation of the product should be avoided, no stress should be applied to the product except from the

instructions given in this document. Cutting, drilling, soldering, adding of electrical and mechanical

components can cause danger and should be avoided by all mean. Not complying with these direction will

result in a lost of the Arthur Holm warranty. Albiral Display Solution S.L. shall not be held liable for any loss

or injury incurred as a result of modifications made to goods by anyone other than the supplier or the

supplier's authorised representative without the supplier's written permission. Such modifications shall be

deemed to terminate any further guarantee obligations. Compensation will not be paid for wages, loss of

profit, waste of time, packing and transport or any financial liability resulting from defects in the goods.

(Albiral Display Solutions shall not be liable for any loss or injury caused by negligence.)

Information