FITNESS AUDIO AEROMIXAMX 123 Kullanım Kılavuzu - Sayfa 3
Müzik Mikseri FITNESS AUDIO AEROMIXAMX 123 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. FITNESS AUDIO AEROMIXAMX 123 5 sayfaları. Voice-over-music mixer
Sayfayı Yazdır'
'
VOICE
VOICE
USB
POWER
USB
POWER
24V DC IN
— MIC INPUTS —
24V DC IN
— MIC INPUTS —
(
' )
' '
(
' )
' '
Key To Illustration:
1.Voice Input 1 Volume
2. Music Input 1 Volume
3. Music Bass & Treble
4. Punch Button for mp3 In
5. Music2 Input Volume
6. iJax Cable Input
4.1 Use the MOM (MUSIC ONLY MONITOR)(22) to drive an on-stage foldback monitor for the
instructors to hear the beat. We recommend using a powered wedge speaker positioned at the
back and centre, firing up from the floor of the stage, of a size and power that will do the job.
You could also install a smaller powered speaker on the ceiling about a metre in front of centre
stage firing down at the instructors head. Itʼs all about letting the Instructors hear the beat as
loud as they want it on stage without the mic giving any feedback problems.
5. Power On
With the speakers connected to the power amplifier, connect the 24VDC Power Pack to
your power point, turn the Power Switch (8) on and make sure the full system is fully powered
up. Thereʼs a cable restraining post to secure the DC plug, so wrap the cable once around to
prevent it being accidentally pulled out.
6. Setting the volume levels.
Start from the end! Firstly adjust the level controls of your power amplifier - set its volume
controls up to maximum. Next set the Master Level (18) on the rear panel to the minimum
point using a small screwdriver and the Mic Trim (14) screwpot to about half way.
6.1 Minimum Level Volume Control
Youʼll notice that the MUSIC 2 Volume Control (5) doesnʼt have a true "off" position. This is
intentional. Set your MP3 Player to the loudest output setting and plug the white iJax cable into
the headphone socket and the other end into the mixer socket (6). Make sure the Music 2
Volume Control is set at minimum. Now start a typical loud track playing from the player and
adjust the Master upwards to establish a minimum loudness level for talk-over purposes. Now
you can increase the loudness from there up to high energy class levels the same as you
would get from a CD.
6.2 Setting the microphone level.
Check that the receiver's mic/line output selector (if there is one) is set to MIC. If you're
using receiver with a variable output volume control then turn the it to the midway or 12 o'clock
position. Next turn the Voice (1) control on the Aeromix up to the 2 o'clock position. Put the
*
&
*
&
MUSIC 1
BASS
TREBLE
MUSIC 1
BASS
TREBLE
MIC
MIC
TRIM
FILTER
MIC INSERT
MIC
MIC
TRIM
FILTER
MIC INSERT
'&
' * ' % ' $ ' # ' !
'&
' * ' % ' $ ' # ' !
7. USB Power Charging
8. Power On/Off
9. 24V DC In
10. USB Power Charging
11. Balanced Mic XLR In
12. TRS Mic Input
%
$
%
$
MUSIC 2
ALT. 2 IN
PUNCH
MUSIC 2
ALT. 2 IN
PUNCH
1
MASTER
1
MUSIC MUTE
CD IN
MP3 IN
VOLUME
MASTER
MUSIC MUTE
CD IN
MP3 IN
VOLUME
' "
' (
' "
' (
13. Mic Insert Socket
14. Mic Gain trim pot
15. Mic Bass Cut
16. Music1 RCA Inputs
17. Music2 RCA Inputs
18. Master Level Control
!
#
"
!
#
"
OFF
USB
POWER
OFF
ON
USB
POWER
ON
—
OUTPUTS
—
4
—
OUTPUTS
—
4
LEFT
RIGHT
MONO
LEFT
RIGHT
MONO
&)
& '
&)
& '
19. Music Mute
Relay Connector
20. Left & Right
Channel Outputs
21. Mono Output
22. Music Only Monitor
(MOM) Output
MOM
MOM
&&
&&