dji Dropsafe Kullanıcı Kılavuzu - Sayfa 7

Drone &; Quadcopter Aksesuarları dji Dropsafe için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. dji Dropsafe 14 sayfaları.

Setting Up the System Base for Deployment

Ensure the "activation switch" and "safety switch" on your remote controller are turned off. Ensure the

spring and triggering pin are within the triggering housing unit. Follow the instructions below to set up the

system base:

Place the trigger compression tool into the triggering housing unit.

screwdriver to rotate the trigger compression tool clockwise for five times and then power on the on-

board battery. The LED indicators on system base will blink red and green for three times to indicate

the system is functional.

2. Press the initialization button to initialize the system. The system LED will blink solid red when the

initialization is completed. If the system LED blinks red, it indicates the signal from remote controller

or flight controller is abnormal. Ensure both the "activation switch" and "safety switch" on the remote

controller are in the OFF position and that the parachute function of your flight controller is enabled.

3. Rotate the screwdriver to tighten the trigger compression tool until the system LED blinks solid

green. Meanwhile, the other system LED will blink red for 9 seconds and then goes off.

DJI DROPSAFE User Manual

×5

Green system LED blinks solid.

Red system LED blinks for 9 secs.

Use the supplied hex