Artidor AR-077 Series Kullanıcı Kılavuzu - Sayfa 6

Aydınlatma Ekipmanları Artidor AR-077 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Artidor AR-077 Series 16 sayfaları. Explosion-safe signal lights

Sayfayı Yazdır

Characteristics

The characteristics can be summarized as follows;



Robust signal light with an attractive, elegant design;



Obtainable as strobe flashing light or as steady burn status light;



Equipped with a factory sealed cable or with a cable gland & connection terminals;



Manufactured out of aluminum (anodized);



Obtainable in six colored lights enabled by colorfast insert lenses;



Manufactured on the basis of the European Directives including the ATEX directive;



Suitable for use in gas and dust hazardous areas Zones 1 & 2 and Zones 21 & 22;



Explosion safety category II 2GD and protection degree against ignition applied:

Ex d IIC T6 or Ex de IIC T6 and Ex tD A21 IP65 T 80˚C;



Sealed against water and dust IP65;



Suitable for internal and external use;



Mounting position 360º.

CE - Marking

The signal lights comply to the European CE Directives for EMC and ATEX and therefore implicitly to the

Low voltage Directive.

With regard to explosion safety the signal lights have been designed and manufactured on the basis of the

essential safety requirements of European directive 2014/34/EU (ATEX 114) relating to Group II Category

2GD. Harmonized European construction standards have been applied fulfilling the essential requirements

of these directives. For more details refer to section 6 Technical data and to the Declaration of Conformity

as shown on the last page of this manual.

Application

The explosion-safe signal lights have been designed for and are suitable for use in hazardous classified

areas due to flammable gases, vapors, mist, fibers and dust. Because they are explosion-safe and certified

on the basis of Group II Category 2 GD of the ATEX Directive they are suitable for use in the hazardous

areas classified as follows:



for combustible gases, vapors and mist: Zone 1 and Zone 2



for combustible fibers and dust: Zone 21 and Zone 22.

The parts used are all manufactured from corrosion resistant materials and are therefore resistant to the

effects of most common chemicals. If use in special environmental conditions is required, please contact the

manufacturer Artidor Explosion Safety B.V.

User manual explosion-safe AR-077 signal light

Issue April 2020

6 / 16