Artila M-508 Hızlı Kurulum Kılavuzu - Sayfa 4

Anakart Artila M-508 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Artila M-508 7 sayfaları.

Factory Default Settings
LAN 1 IP Address: 192.168.2.127
Login: guest
Password: guest
Supervisor: root (use ssh to login)
Password: root
Serial Console: Disabled
Network Settings
To configure the IP address, Netmask and Gateway setting, please
modify /disk/etc/rc as following:
ifconfig eth0 192.168.2.127 netmask 255.255.255.0
For DHCP setting:
dhcpcd eth1 &
Wireless LAN Configuration
M-508 supports wireless LAN by using USB WLAN adaptor
which uses Ralink RT2571 (rt73) controller. Please refer to the
website http://ralink.rapla.net for the supporting list of the USB
WLAN adaptor.
To configure the wireless LAN setting, please use command:
modprobe rt73
ifconfig wlan0 up
iwconfig wlan0 essid XXXX key YYYYYYYY mode MMMM
For infrastructure mode XXXX is the access point name and
YYYYYYYY is the encryption key and MMMM should be
managed
For Ad-Hoc mode mode XXXX is the M-508 host name and
YYYYYYYY is the encryption key MMMM should be ad-hoc.
To configure the IP address use command
dhcpcd wlan0 & or ifconfig wlan0 192.168.2.127 netmask
255.255.255.0
File System
M-508 configures the root file system as RAMDISK and the user
disk (/disk) which includes /home and /etc directory are
configured as Flash Disk. To find out the file system information,
please use command /mount as shown as below. In addition, use
command /df to find out the disk space of the disk. The
RAMDISK uses 8MB SDRAM space to store the root file system
and 8MB for uboot loader and Linux Kernel Therefore it is about
16MB free SDRAM for user application software. The image of
Linux kernel and root file system is stored in the flash memory
and it uses about 4MB flash memory space and the rest of 12MB
flash memory is designed for user flash disk to store user's
program.
Therefore, user's program and utility software must be saved
in the user disk space (/disk). Files saved to other directory
The second flash memory is configured as disk-1 and its
available space is 15MB. In addition, M-508T is equipped with
512KB FRAM and it is configured as sram
Devices list
The supported devices are shown at /dev directory. Following
list are most popular ones:
1.
ttyS0: serial console port
2.
ttyS1 to ttyS4: serial port 1 to port 4
3.
mmc to mmc2: SD memory card
4.
sda to sde: USB flash disk
5.
ttyUSB0 to ttyUSB1: USB RS-232 adaptor (fdti_sio.ko)
6.
rtc: Real Time Clock
7.
gpio: General Purpose digital I/O
8.
ttyACM0 and ttyACM1: USB Modem (CDC compliant)

Utility Software:

M-508 includes busybox utility collection and Artila utility
software as follow:
48