3Jtech DWR Hızlı Kurulum Kılavuzu - Sayfa 3

Kablosuz Yönlendirici 3Jtech DWR için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. 3Jtech DWR 3 sayfaları. Dedicated wifi router

Ver 1.0.0.0

－ Connecting other wireless devices to the DWR

(Please skip this section if you would like to use our wireless IP camera series.)

1) Connect the power cable to the power jack of DWR.

2) Connect the wireless device to a LAN port of DWR via the RJ-45 cable.

3) Power on the wireless device.

4) Initiate your Internet Explorer and type http://192.168.8.1 into IE browser. Click OK

button to enter the setup page of DWR after inputting the following username and

password.

5) Please go to Wireless / Basic Settings by pulling down the function list located at the

left side.

6) In Wireless Basic Settings page, please use the values of WEP Key and SSID fields to

set up your wireless devices. (Note: The wireless devices will get the SSID belonging

to the DWR automatically if the function of broadcast is enabled.).

4. Restore Factory Default Settings

DWR provides the Def. button that will be easy for users to

reset the router to its factory defaults. The button locates in

the bottom of the DWR (See Def. button of the figure at the

right side). Resetting steps are as follows:

(1) Move the cover in the bottom of the router.

(2) Plug in the power cable and wait around 20~30 seconds.

(3) Press the Def. button and keep it pressed around 7

seconds.

(4) The DWR will restart after releasing the Def. button.

Username: cameras

Password: cameras

Def. BUTTON