Custom Dynamics Dynamic Strips CD-DS-ST-B Kurulum Talimatları Kılavuzu - Sayfa 2

Motosiklet Aksesuarları Custom Dynamics Dynamic Strips CD-DS-ST-B için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Custom Dynamics Dynamic Strips CD-DS-ST-B 7 sayfaları.

Sayfayı Yazdır

Identify the LEFT side ST-HARNESS connections labeled

with a sticker marked "L", they need to be routed over to

the left side of the bike. There is a small hole at the base of

the frame that the harness will run through. Pull the rubber

cover back and insert each red connector one at a time

through the hole, be sure to pull any slack available from

the other side. You may also remove the label.

Push the main part of the ST-HARNESS in behind the

rubber frame cover, leaving the output side of the harness

visible from the outside.

Questions? Call us at: 1 (800) 382-1388

Installation Instructions - Page 2

Left side of the

bike

M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST

The wires exiting the ST-HARNESS are paired with shrink

tube coverings. Take the Yellow and black paired wires and

twist them together as shown in the photo. Pair the White

and black wires in the same manner. Repeat for the Right

side connections on the ST-HARNESS.

Route the ST-HARNESS output wires in behind the brake

and clutch lines on the frame to ensure they won't interfere

with them. Re-install the gas tank to the frame by following

the instructions in the detailed manufacturer service

manual. The Harness part of the installation is complete,

we now have our connections for the Dynamic Strips™.

Twist

12-2016SM