DK Digital AS-200 Kullanıcı El Kitabı - Sayfa 10
Ev Sinema Sistemi DK Digital AS-200 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. DK Digital AS-200 12 sayfaları. 1.1 home cinema surround system
Sayfayı Yazdır
10 RADIO:
Use this button to activate the built-in tuner.
11 STEREO IN:
Press this key to activate the 3 stereo inputs one after the other.
12 MUTE:
Press this button to silence the sound. Press it again to reactivate the sound.
Operating the Home Cinema Set
Connect the plug of the power cord to a properly connected AC230V power socket. Set the
mains switch (MAIN POWER) on the backside of the subwoofer to the ON position (I). The
system is now in operation and the display shows the current operation mode.
Playback of external signal sources
1. Press the INPUT key to activate the available inputs :
TV IN
AUX IN
=>
As an alternative, you can also . . .
- press the RADIO key on the remote control to switch to tuner mode.
- press the DVD / 5.1 CH key to activate the 5.1-channel input
- press the STEREO IN key to activate the inputs
other.
2. You can adjust the volume via the MASTER VOL "+" and "—" keys on the remote
control. Press the "+" key to increase the volume and the "—" key to decrease the
volume. The volume which has been set is shown on the display.
3. You can adjust the volume of the individual speakers in relation to each other or the
sound spectrum during operation mode by doing the following:
—
Adjust the total volume to an appropriate value.
—
Press the FUNCTION key once. After that you can change the volume of the two front
speakers via the MASTER VOL "+" and "—" keys.
—
Press the FUNCTION key twice. After that you can change the volume of the centre
speaker via the MASTER VOL "+" and "—" keys.
—
Press the FUNCTION key three times. After that you can change the volume of the
subwoofer via the MASTER VOL "+" and "—" keys.
—
Press the FUNCTION four times. After that you can change the high sound proportion
of the sound spectrum via the MASTER VOL "+" and "—" keys.
—
Press the FUNCTION key five times. After that you can change the low sound proporti-
on of the sound spectrum via the MASTER VOL "+" and "—" keys.
Radio mode
1. If you have switched to radio mode, a frequency value is shown on the display. If "
MHz (megahertz) is displayed, the FM band is active. If "
displayed, the MW band is active. You can switch between the two frequencies via the
FM/AM key on the remote control or via the system.
one after the other.
AC-3 IN
CD IN
=>
10
(5.1) => Radio =>
TV IN
AUX IN
=>
one after the
KH
" for kHz (kilohertz) is
CD IN
=>
M
" for