Artison 5B-1 Kurulum Kılavuzu - Sayfa 3

Konuşmacılar Artison 5B-1 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Artison 5B-1 9 sayfaları.

MOUNTING THE TELEVISION MOUNTING BRACKET (TMB)

When the flat panel television is mounted to the wall, the Television Mounting Bracket (TMB) is

designed to sandwich between the television's wall mounting bracket and the television's chassis.

When the application calls for using a flat panel with a table top stand, the TMB can be attached

directly to the back of the flat panel display using the same wall mounting points. The TMB can be

attached such that the SoundBar is located either on top or bottom of the display.

1. Remove the flat panel display from its box or where it is mounted and lay it display-side down

on a large, flat, soft surface. NOTE: This step may require TWO PEOPLE.

2. Find the correct size and quantity of screws, washers and spacers from the supplied hardware

selection located in the Hardware Box. If you are using mounting screws that are either M4,

M5 or M6 please use the appropriate collar washer to ensure a secure fit for the screws in the

TMB mounting slots. If you are using the M8 mounting screws the collar washers are not

needed.

3. Position both TMBs vertically on the rear of the display so that the slots line up with the wall

mounting points on the television's chassis. One bracket should be placed vertically across

one set of mounting points and one bracket should be placed vertically across the other set of

mounting points. Make sure to leave the ends with two threaded screw holes on the side of

the television that you want to mount the speaker. See Figure 1.

4. If applicable, place your wall mounting brackets that the television will be hung by on top of the

TMBs.

5. Then loosely thread the mounting screws thru the bracket assemblies.

6. Place the TMB offset fixtures into the ends of the TMBs that have the two threaded screw

holes that match the raised plastic areas on the fixtures. See Figure 2.

7. Press the end of the TMBs that now have the offset fixtures towards the television bezel until

the offsets touch or align to the television bezel edge. This will place the TMBs in the proper

position for the installed grille to fit snuggly against the bezel.