DK-TEC HNEFGCH Kullanıcı Kılavuzu - Sayfa 12

Çiftlik Ekipmanları DK-TEC HNEFGCH için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DK-TEC HNEFGCH 16 sayfaları. Flail mower

Sayfayı Yazdır

Installing the V-belt:

CAUTION: The strap is very tight; use caution to avoid bodily harm!

1. Remove strap guard and strap coverage.

2. Release the belt tension by loosening

3. With the tension relieved from the strap, the old strap is removed from the pulley

and a new one is inserted.

4. Tighten the belt tension bolt.

5. Replace the belt guard and belt cover .

Adjusting the height

To get the most out of your flail mower, it must be installed within the recommended height. To

spare fuel, power and reduce wear and tear on the machine, the cutting height must be adjusted

correctly.

When the working height needs to be adjusted, bolt No. 1 must be loosened, and bolt No. 2

removed on both sides. The height of the carrier roller (see drawing below) can be adjusted by

adjusting the selected hole in the carrier roller bracket in position 2. In the lowest hole, it is the

highest working height. Put the screw in the selected hole and tighten the screw from bolt No. 1

and bolt No. 2.

The rest of the height adjustment is made with a raise/lower

of the tractor's lift arms and corresponding adjustment of the

top bar.

Do not carry passengers on the flail mower:

Passengers can block the driver's sight and therefore

cannot see where they are being driven. Never allow

passengers on the flail mower.

Practical safety maintenance:

•

the maintenance procedures before starting maintenance. Use safe and

Understand

approved tools for maintenance. Read the manual for more information regarding

maintenance.

•

Maintenance should always be done in a dry room.

•

Lower the machine to the ground, put the tractor in

remove

key before performing the maintenance.

the

•

Before carrying out maintenance

•

Do not lubricate parts in grease or oil while the machine is working.

•

Inspect all parts. Make sure that all parts are in good condition and that they are correctly

installed before using the machine.

•

Remove accumulations of fat, oil and/or swans.

•

Remove all tools and unused parts from the machine before use.

tightening bolt until

the

all parts must be cooled.

strap can be removed.

the

parking, turn off the engine and