Altura Photo AP-FLS-UNV1 Kullanıcı Kılavuzu - Sayfa 5

Kamera Flaşı Altura Photo AP-FLS-UNV1 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Altura Photo AP-FLS-UNV1 8 sayfaları.

• Set the power switch to the ON position. All lights will come

on.

• To test the flash press the TEST button.

• Start taking pictures when the power light is red.

• Turn the power off when done and only remove batteries

while in the off position

2. Flash Intensity control

• There are 8 settings to control the output of the flash.

• They range from 1/128 1/64 1/32 1/16 1/8 1/4 1/2 and 1/1 (full power output).

• Select the desired level of output by pressing the + or – button.

3. M Mode

• This is your shooting mode when the flash is mounted on the camera. To select

the M mode press the Mode button until M is illuminated.

• Your flash is synched to your camera and will fire when you take a picture.

4. S1 Mode

• This is the shooting mode to take pictures using this flash as a slave.

• Use this mode when your built in camera flash or master flash is set to Manual

mode.

5. S2 Mode

• This is the second mode to use when you want to take pictures using this flash

as a slave.

• Use this mode when your built in camera flash or master flash is set to TTL

mode.

6. Automatic Save Function

• The last flash settings that you had before turning off the flash will be automatically

saved. The settings will be saved even if you change the batteries.

7. PC Synchronous Port Output

• By connecting to this port you can remove the flash from the hotshoe. When the

flash sync is triggered, a signal is sent from the camera along the wire to the flash

telling it to fire.

8. External Power Supply Box

• Flash has a standard Canon external power socket. By using an external power

supply you will extend the capacity of your flash.