ARTIST PSW100 Kullanıcı Kılavuzu - Sayfa 4

Müzik Enstrümanı ARTIST PSW100 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ARTIST PSW100 4 sayfaları. Power winder 3-in-1 tool

Restringing with the Patatuss Penguin

1. Place the instrument in a secure spot and carefully unwind the string with

the Penguin.

PSW100

☞ Caution | Removing the strings one at a time is recommended. Removing

all 6 guitar strings at the same time could cause problems due to rapid tension

change.

2. After inserting the bridge pin rmly into the bridge pin puller of the

Penguin, lift up, and the bridge pin will release smoothly.

PSW100

☞ Caution | In the case where the bridge pin has not been inserted fully into

the bridge pin puller, the leverage e ect on the partially hooked pin can

damage the bridge of the guitar as well as the puller itself.

3. Insert a new string into the bridge hole and x it with the bridge pin. At this

point, pull the string in order to make sure that it is correctly xed.

4. After spreading the string across the string peg, cut it while leaving 4~5cm

of the 4th, 5th, and 6th strings and approximately 6~8cm of the 1st, 2nd, and

3rd strings.

☞ Caution | When cutting the string, do not place your ngers between the

handle and body. You could injure yourself.

5. Insert guitar strings into the peg holes and wind up the string using the

Penguin. At this point, you should maintain the tension of the string by

PSW100

pulling the string with your other hand. The number of times this should be

performed is between 2~3 in the case of the 4th, 5th, and 6th strings, and

approximately 4~6 times in the case of the 1st, 2nd, and 3rd strings.

☞ Caution | Fine tuning is best done manually. Do not use this product to

wind the string all the way to end, or for tuning, since the strings could

become damaged. When winding up the string, arrange it evenly according

to the picture and wind up the peg at least 2~3 times so that correct, precise

tuning can be achieved.

6. Change the rest of the strings as outlined in steps 1~5.

7. Fine tuning should be directly nished by hand. At this point, even though

tuning has been completed, you should repeat the tuning process while

pulling the strings to ensure that accurate pitch can be maintained.

Artist String Winder