DK2 12SPS12 Montaj ve Kullanım Talimatları - Sayfa 9

Vinçler DK2 12SPS12 için çevrimiçi göz atın veya pdf Montaj ve Kullanım Talimatları indirin. DK2 12SPS12 20 sayfaları. Electrical winch

Never connect the cable back to itself.

damage.

strength as shown in the illustrations.

Store the remote control inside your vehicle in a place that it will not

be damaged.

Any winch that appears to be damaged in any way, is found to be

worn, or operates abnormally SHALL BE REMOVED FROM

SERVICE UNTIL REPAIRED.

necessary repairs be made by a manufacturer's authorized repair

facility.

Pull only on areas of the vehicle as specified by the vehicle

manufacturer.

Only attachments and/or adapters supplied by the manufacturer

shall be used.

Self Recovery

Fig 3.1

Fig 3.2

Fig 3.3

Always use a snatch block, sling or chain of suitable

RIGGING TECHNIQUES

Locate a suitable anchor such as a strong tree trunk or boulder.

Always use a sling as an anchor point.

the clevis hook back onto the cable as this could cause damage to

the cable.

As shown in Fig 3.1

Do not winch from an acute angle as the wire rope will pile up

on one side of the drum causing damage to wire rope and the

winch. Fig 3.2

Short pulls from an angle can be used to straighten the vehicle.

Long pulls should be done with the wire rope at a 90° angle to the

winch/vehicle.

When pulling a heavy load, place a blanket or jacket over the wire

rope five or six feet from the hook. In the event of a broken cable it

will dampen the snap back. For additional protection open the

hood of the vehicle as shown in Fig 3.3

This will cause cable

It is recommended that the

CAUTION Do not attach