DKB HEAT 3 burner bbq Kullanıcı El Kitabı - Sayfa 10

ızgara DKB HEAT 3 burner bbq için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. DKB HEAT 3 burner bbq 13 sayfaları. Dkb heat 3 burner bbq 30 mbar owners manual

Sayfayı Yazdır
TROUBLE SHOOTING
Problem
SMELL OF GAS
Leak detected at gas bottle, regulator or
other connection.
Flame fl ashback beneath control panel.
Burner will not light.
Decreasing heat, "popping sound" .
Hot spots on cooking surface.
"Flare-ups" or grease fi res.
Humming noise from regulator.
Yellow Flame.
Possible cause
SHUT OFF LP GAS BOTTLE VALVE AT ONCE.
DO NOT USE THE APPLIANCE UNTIL LEAK IS SEALED.
1. Regulator fi tting loose.
2. Gas leak in hose/regulator or control
valves.
1. U-pipe burner blocked.
1. Out of Gas.
2. Ignitor wire(s) not connected.
3. Ignitor electrode misaligned on burner.
4. Ignitor malfunction.
5. Regulator is not fully connected to the
gas bottle valve.
6. Burner valve left open while gas bottle
valve was opened causing excess fl ow
device to activate.
7. A leak in the system causing the excess
fl ow device to activate.
8. U-pipe burner blocked.
9. U-pipe burner not aligned with valve
orifi ce.
10. Orifi ce blocked.
11. Hose is twisted.
1. Out of Gas.
2. U-pipe burner blocked.
1. U-pipe burner blocked.
1. Excessive grease buildup.
2. Excessive heat.
1. Gas bottle valve turned on too quickly.
1. Some yellow fl ame is normal. If it
becomes excessive the U-pipe burner
may be blocked.
2. Burner ports blocked.
10
Corrective action
1. Tighten fi tting and "Leak Test" .
2. See authorized service centre.
1. Remove burner, clean burner pipe.
See "Cleaning of U-pipe burners" .
1. Refi ll Gas bottle.
2. Connect electrode wires.
3. Realign electrode.
4. Use "Manual Lighting" Procedure.
5. Tighten the regulator hand wheel.
6. Close burner and gas bottle valves.
Open gas bottle valve slowly, then open
burner valve to light.
7. Leak test connections to determine loose
fi tting. Tighten fi tting. Leak test system.
8. Remove burner, clean U-pipe burner.
See "Cleaning of U-pipe burners" .
9. Realign U-pipe burner to orifi ce.
See "Cleaning of U-pipe burners" .
10. Remove burner, clean orifi ce with a pin or
fi ne wire. Do not attempt to drill orifi ce.
11. Straighten hose.
1. Refi ll Gas bottle.
2. Remove burner, clean U-pipe burner.
See "Cleaning of U-pipe burners" .
1. Remove burner, clean U-pipe burner.
See "Cleaning of U-pipe burners" .
1. See "Maintenance" .
2. Turn burner controls to a lower setting.
1. Turn gas bottle valve on slowly.
1. Remove burner, clean U-pipe burner.
See "Cleaning of U-pipe burners" .
2. Remove burner & clean with soft bristle
brush.