CustomWorks INTIMIDATOR GSX2 Manuel - Sayfa 5

Motorlu Oyuncak Araba CustomWorks INTIMIDATOR GSX2 için çevrimiçi göz atın veya pdf Manuel indirin. CustomWorks INTIMIDATOR GSX2 17 sayfaları. Racing kit

Sayfayı Yazdır

Bag D

Rear Suspension

-Parts for

Step#1

3241

Qty 2

Bearing Carrier

-Parts for

STEP#2

7211

Qty 2

CVD Coupling

-Parts for

STEP#3

5223

1 3/4" TI Turnbuckle

STEP #1

5230

4235

- Press 1226 Ball Bearings into the 3241 Bearing Carrier.

- Attach the Bearing Carrier to the Susp Arm using 4235

Susp Pin with (2) 1255 Spacers on each side of the

Bearing Carrier.

- NOTE: The Suspension Pin will pass thru the UPPER

hole in the Bearing Carrier.

- Retain the Susp Pin using 5230 E-Clips.

STEP #3

- Assemble the camber links by threading

the 5235 Ball Cup on each end of the

5223 Turnbuckle. Attach by snapping the

Ball Cups onto the Ball Studs.

5225

7214 MEDIUM BONE

1:1

1226

Qty 4

Ball Bearing

7214

Qty 2

Medium Dogbone

Qty 2

5235

Qty 4

Ball Cup

3241

1226

- Attach the 8122 Ball

Stud to the Rear

Bulkhead as shown

using a 5217 Lock Nut.

8122

4235

Qty 2

1:1

Rear Outer Susp Pin

7216

Qty 2

7211

Rear CVD Axle

Rear CVD Pin

1:1

7047

Qty 8

Spacer

STEP #2

1255

7214

- Apply grease to the areas shown.

- Apply thread-lock (Loctite) to the set screw.

- Align the holes as shown so that the

7211 CVD Pin can pass thru the Bone,

Axle, and Coupling. Pin should be evenly

spaced in the DogBone.

-Tighten the Set Screw by angling the Bone

and Axle so the set-screw is able to be tightened.

- Slide the thick shim packaged

with the CVD parts onto the CVD

Axle, Insert the CVD assembly by

sliding the axle thru the bearings.

5217

7214

5225

1255

Qty 10

Spacer

1:1

Qty 2

7211

Qty 2

CVD Set Screw

8122

Qty 4

7203 Qty 2

Ball Stud

Roll Pin

7211

(Pin)

XXXX

Qty 4

Ball Stud

- Slide a 1255 Spacer onto

the Ball Stud and thread

into the Bearing Carrier in

the outer most hole.

8122

1255

7203

7047

- Add or remove 7047

Shims if necessary so

wheel spins freely when

tightened down.

1:1

5230 Qty 24

E-Clip

5217

Qty 2

4-40 Lock Nut

7216

7211

(Coupling)

7211

(Set Screw)

- Slide (4) 7047

Shims onto the

axle and retain

using the 7203

Roll Pin. Pin should

be evenly spaced

in Axle.