Alula RE129 Kurulum Kılavuzu

Güvenlik Sensörleri Alula RE129 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Alula RE129 2 sayfaları. Glassbreak break detector
Ayrıca Alula RE129 için: Manuel (2 sayfalar)

Sayfayı Yazdır

Resolution Compatibles

The RE129 Glassbreak

detects the sound of breaking glass and sends alarm

signals to the security panel.

Features

• Variable detection range of up to 20 feet

• Low battery and tamper indication

• VHB™ tape included for easy installation

Enroll

by placing the panel into wireless enrollment

mode and removing the battery tab.

Select sensitivity by adjusting the dipswitch. See

table below for sensitivity settings.

SENSITIVITY

MAX

MEDIUM

LOW

LOWEST

Select a mounting location

6.5 feet (2m) and no more than 20 feet (6m) from the

window you wish to protect. Ensure the sensor has

visual line-of-sight to all windows being protected.

Use a glassbreak tester to confirm operation before

permanently mounting using the mounting screws or

VHB tape.

Test the glassbreak

enrollment and installation. Note, any glassbreak

tester can be used.

1. The sensor is in test mode for 5 minutes after

powered. When test mode is active, the LED will

flash once per second.

2. Activate the glassbreak tester near the window

you wish to protect.

3. If an alarm is detected, the LED will flash rapidly

for 2 seconds and an alarm signal will be sent

to the panel. If the sensor does not trip, check

the sensitivity setting or relocate the sensor and

retest.

Use the panel installation guide to verify proper system setup.

RE129 Glassbreak

Interlogix

is a security sensor that

DETECTION

SWITCH 1

RANGE

20FT

13FT

8FT

5FT

at a height of at least

to verify operation after

Compatible

SWITCH 2

OFF

Mounting Holes

Sensitivity Switches