Alula RE606M Hızlı Başlangıç Kılavuzu

Aksesuarlar Alula RE606M için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Alula RE606M 2 sayfaları. Tilt sensor connect+ encrypted

Sayfayı Yazdır

RE606M Tilt Sensor

transmitter typically used to sense the tilt of overhead

garage doors and windows. It will alarm when the

sensor is tilted more than 45 degrees.

Features

• New, high accuracy MEMS sensor

• Industry-leading wireless range and battery life

• Secure encrypted wireless transmissions

Enroll

by placing the panel into wireless enrollment

mode and then sending an enrollment signal

from the sensor. Alternatively, the sensor can

be enrolled by scanning its bar code using

the Connect+ Installer App or by entering its

8-character serial number in the AlulaConnect™

portal.

Sending an Enrollment Signal

• Remove the battery tab or trip the tamper

Install

by mounting the sensor to the inside of

a door or window using the mounting screw

locations. For garage door installations, the

sensor should be mounted to the top panel of the

overhead door. This ensures that the

sensor closes only when the door

is fully closed, and is best for RF

range.

Tilt Detection

sensor exceeds a 45 degree angle.

If the sensor rotates further than

135 degrees, it is likely to remain

in a non-alarm state. For best

results, the sensor should rotate

within 90 degrees to ensure an

alarm state occurs.

Use the panel installation guide to verify proper system setup.

is a full-featured security

occurs when the

RE606M Tilt Sensor

Connect+

™

Encrypted

Mounting

Screw

Holes

Cover-Securing

Screw Hole