Alula RE667 Manuel - Sayfa 4

Dokunmatik panel Alula RE667 için çevrimiçi göz atın veya pdf Manuel indirin. Alula RE667 12 sayfaları. Slimline touchpad
Ayrıca Alula RE667 için: Manuel (13 sayfalar), Manuel (12 sayfalar)

Sayfayı Yazdır

2. There are two methods for connecting power to the Touchpad.

A. If you desire to hide the power cable, you can drill a hole in the wall through one of the

four windows in the mounting plate and pull a wire behind the drywall to a location with

an AC power outlet. Connect one end of the wire to the terminal block on the back of the

tablet. Push the buttons on the terminal block to allow the wire to be inserted. Splice the

other end of the wires to the power supply wires after cutting off the barrel jack.

PROVIDED POWER SUPPLY.

must not exceed lengths listed below.

B. Barrel jack of the power supply can be plugged directly into the back of the Touchpad.

Wires can be routed through wire channel in the back of mounting base. This configuration

requires the barrel jack be routed through the mounting base before the mounting base is

screwed to the wall.

3. Slide the Touchpad

onto the mounting plate.

Push any extra wire into

wall before sliding onto

mounting plate.

6. Plug in power supply.

Power from an existing panel may be

WIRE

MAXIMUM LENGTH BETWEEN

GAUGE

POWER SUPPLY AND TABLET

#24

Up to 70 feet

#22

Up to 100 feet

#20

Up to 175 feet

#18

Up to 250 feet

#16

Up to 450 feet

4. Drop cover behind

Touchpad.

insufficient. Wire length

5. Lock in cover by pressing

at these locations until

snapped into place

MUST USE