Alula RE314 Hızlı Başlangıç Kılavuzu - Sayfa 3

Duman Alarmı Alula RE314 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Alula RE314 13 sayfaları. Smoke alarm dsc compatible

Sayfayı Yazdır

benefits that the user is reminded every 10

minutes by two short beeps that the Alarm

needs to be replaced and that if the problem

clears the Alarm will return to detecting fire).

1.2.3. Faulty smoke chamber

In the unlikely event of the smoke sensing

chamber becoming defective, the Alarm will

give 2 short beeps with 2 yellow LED flashes

every 48 seconds. The Alarm must then be

replaced.

If it is not convenient to replace it immediately,

pressing the test button will silence the beeps

and stop the yellow LED flashing for 12 hours.

This can be repeated as required.

2. Location and Positioning

Introduction

Congratulations on purchasing a Smoke

Alarm. You can easily install these Alarms

throughout the property on escape routes, on

each storey, in corridors and in closed rooms to

give warning of fire.

Heat Alarms can be installed in kitchens

and other areas where Smoke Alarms are

unsuitable.

NATIONAL FIRE PROTECTION ASSOCIATION

REQUIRED PROTECTION

Smoke Detection. Where required by

applicable laws, codes, or standards for the

specified occupancy, approved single- and

multiple-station Smoke Alarms shall be

installed as follows:

(1) In all sleeping rooms and guest rooms

(2) Outside of each separate dwelling unit

sleeping area within 6.4 m (21 ft) of any door

to a sleeping room, the distance measured

along a path of travel

(3) On every level of a dwelling unit, including

basements

(4) On every level of a residential board

and care occupancy (small facility), including

basements and excluding crawl spaces and

unfinished attics

(5) In the living area(s) of a guest suite

(6) In the living area(s) of a residential board

and care occupancy (small facility)

Are More Smoke Alarms Desirable? The

required number of smoke detectors might

not provide reliable early warning protection

for those areas separated by a door from

the areas protected by the required smoke

detectors. For this reason, it is recommended

that the householder consider the use of

additional smoke detectors for those areas

for increased protection. The additional areas

include the basement, bedrooms, dining room,

furnace room, utility room, and hallways not

protected by the required smoke detectors.

The installation of smoke detectors in kitchens,

attics (finished or unfinished), or garages is

not normally recommended, as these locations

occasionally experience conditions that can

result in improper operation.

The equipment should be wired and installed

in accordance with National Fire Protection

Association's Standard 72, Chapter 11 and

National Electric Code, NFPA 70, Chapter

3. (National Fire Protection Association,

Batterymarch Park, Quincy, MA 02269).

For Canadian installations wiring methods

shall be in accordance with CSA C22.1,

Canadian Electrical Code, Part I, Safety

Standard for Electrical Installations. Testing

and maintenance procedures shall be in

accordance with CAN/ULC-S552, Standard for

the Maintenance and Testing of Smoke-Alarms.

IMPORTANT!

Specific requirements for Smoke Alarm

installation vary from state to state and from

region to region. Check with your local Fire

Department for current requirements in your

area.

SMOKE ALARMS

Sufficient smoke must enter your Smoke Alarm

before it will respond. Your Smoke Alarm

needs to be within 6.4 metres (21ft) of the fire

to respond quickly. Smoke Alarms also need

to be in positions where they can be heard

throughout the property, so they can wake

you and your family in time for everyone to

escape. A single Smoke Alarm will give some

protection if it is properly installed, but most

homes will require two or more (preferably

interconnected) to ensure that a reliable early

warning is given. For recommended protection

you should put individual Smoke Alarms in all

rooms where fire is most likely to break out

(apart from the kitchen and bathroom).

Your first Smoke Alarm should be located

between the sleeping area and the most likely

sources of fire (living room for example), but it

should not be more than 6.4 metres (21ft)from

the door to any room where a fire may start

and block your escape from the house.

Multi-Storey Dwellings

If your home has more than one floor, at least

one Alarm should be fitted on each level (see

Figure 1). Preferably the Alarms should be

interconnected (if feature is present on unit)

so as to give sufficient warning throughout

the property.

Figure 1 illustrates where Smoke and Heat

Alarms should be located in a typical two

storey house. Note the spacings in "Protection

Levels" which ensure the early detection of fire

and that the warning will be heard.