Alumax ProLine PL50 Kurulum Talimatları Kılavuzu - Sayfa 4

Muhafaza Alumax ProLine PL50 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Alumax ProLine PL50 8 sayfaları. Frameless sliding enclosure

Sayfayı Yazdır

Measure one of the glass Door Panels [A] and subtract

4 1/2". That is the distance up from the sill that you will

place the BOTTOM of the two Wall Mount Brackets [B].

Using a wall mount bracket as a guide, and holding it level,

mark the hole locations on the walls, making sure that it is

located so that the center guide can be installed properly in

Step 5 of this instruction. Drill the four holes 3/8" diameter.

Insert the four Wall Anchors [C] into the holes and attach

the wall mount brackets with the four Wall Mount Bracket

Screws [D].

NOTE: For an out of level sill, install the wall mount bracket

on the high side as described, and use a level and the

cut header bar (step 2) to locate and install the opposing

bracket.

NOTE: There are four large anchors and two smaller ones

used to mount the center guide in Step 5 of this installation

instruction.

OPTIONAL: If the anchors are not used, Drill a 1/4"

diameter clearance hole, just through the tile and a pilot

hole into the wall stud. Install the wall mount brackets as

described above.

Measure the distance across the opening near the top

of where the shower door is going to be. Subtract 3/4"

and cut the Header Bar [E] to that length. File down any

burrs created by cutting the header bar.

NOTE: There are spacers placed down the length of the

header, between the two rectangular tubes. You will need

approximately 5 inches on each end with no spacers, to

get the Stoppers [F] positioned correctly. You may have to

make two cuts.

Slide two Stoppers [F] over each end of the header

bar, with the rubber bumper on the top side of the bar

and pointing towards the middle of the header bar. Do not

tighten the set screws at this point.

Page 4 of 8