Alumax SPEEDSTALL 794S Series Kurulum Talimatları Kılavuzu - Sayfa 4

Muhafaza Alumax SPEEDSTALL 794S Series için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Alumax SPEEDSTALL 794S Series 9 sayfaları. Shower enclosure

Sayfayı Yazdır

The A

794

LUMAX

is completely reversible and may be installed pivot-left or

pivot-right. For maximum waterproofing, the pivot jamb

should be opposite the shower head. Using the diagram,

determine the correct position for the door in your

particular S

installation. This instruction sheet

PEED

TALL

depicts a pivot-right installation.

CAUTION: For safety reasons, the door panel must

always open outward.

NOTE: If the curb and header sections come pre-

assembled, skip to Step #3.

Assemble the curb sections [A] (with weep slots) by

sliding a 135° anchor plate [B] into the mitered ends and

forcing the sections together. The weep slots in the curb

must be to the inside. Screw four #8 x 1/4" truss head

screws [C] through the slots in the anchor plates into the

curbs. As you tighten the screws, be sure the mitered ends

are forced tightly together. To increase the rigidity of the

mitered joint, drill 1/8" holes into the curb through the

round holes in the anchor and install two more #8 x 1/4"

screws.

Assemble the two header sections [D] in the same manner

and set the header assembly aside.

Measure the opening at the bottom of the shower

stall and trim the ends of the curb assembly [A] (with

weep slots) to fit the shower sill. The curb should sit near

the centerline of the sill. If required, use a file to round

the lower ends of the curb assembly to fit the shower sill

properly.

Using a 3/16" drill bit, drill the interior face of the curb

assembly on both ends as shown.

Reposition the curb assembly on the shower sill and mark

its position with a pencil line along the interior and

exterior base.

G03711103

8-22-06

Shower Enclosure

PEED

TALL

Page 4 of 9