Alumax Stickstall 794 Series Kurulum Talimatları Kılavuzu - Sayfa 6

Duş Kabinleri Alumax Stickstall 794 Series için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Alumax Stickstall 794 Series 11 sayfaları. Shower enclosure

Sayfayı Yazdır

- ALL DOORS

Place the setting blocks [H] into the curb [A]

as shown to support the fixed glass panels [J].

Locate the setting blocks 3" from the corners of the

glass panels. Set the first glass panel into place on

the setting blocks and approximately 1/2" into the

wall jamb [E].

A strip of masking tape 1/2" from

each vertical edge of the glass will aid alignment.

NOTE:

Obscure glass panels should be installed

with the rough surface of the glass to the exterior

of the unit.

Deco or etched glass panels should

have the patterned surface to the inside.

Press a 135° post [K] into the curb assembly.

should overlap the glass panel by 1/2". Use masking

tape to hold the post in position temporarily.

Repeat the glass and post installation on the

opposite panel.

- ALL DOORS

Hold the two 135° posts [K] plumb and

carefully measure horizontally from the top of

each wall jamb [E] to the outside corner of each

post (see illustration).

measurement to find the corresponding dimension

on the header assembly [D] (from the outside

mitered corners to the squared ends) and trim the

header assembly to fit.

NOTE:

To facilitate out of plumb walls, the 1/2"

glass bite may be varied from 1/4" to 3/4".

Using a 3/16" drill bit, drill the interior face of the

header assembly on both ends as shown.

- ALL DOORS

Press the header assembly [D] over the wall

jambs [E] and the 135° posts [K]. Check the posts

for plumb.

Adjust as required by varying the

overlap of the header over the wall jambs.

may need to trim the ends of the header where it

meets

the

wall.

dimension for the door opening is the door panel

width (see the graphic in Step #9) plus 3/4",

maximum is the door panel width plus 1 3/4".

Using the holes in the ends of the header and curb

as a guide, drill four 1/8" holes into the wall jambs.

Drill four 1/8" holes thru the header and curb into

the two posts as shown, then enlarge the four

outer holes with a 3/16" drill for clearance on the

self-tapping screws.

to the wall jambs and posts with eight #8 x 1/4"

truss head screws [C].

CAUTION:

Slide the glass panels away from the

jamb or post before drilling to prevent

EPH-N00-06003

5-20-97

Add 3/16" to each

The

minimum

horizontal

Secure the header and curb

breakage.

You

Page 6 of 11