CUTRA CtrlAX Kullanım Kılavuzu - Sayfa 12
Kişisel Bakım Ürünleri CUTRA CtrlAX için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CUTRA CtrlAX 16 sayfaları.
Sayfayı Yazdır�
▶ Please check the following items before requesting repair.
Symptoms
The power won't turn on
The device does not work
after pressing the operation
button.
The handpiece makes noise
and does not cut well
P. ��
Checklist
Does the LED of the
power button not light up?
Does the power still not turn on
even after connecting the adapter?
Is the power button turned off?
After pressing the operation button,
did you let go of it too quickly?
Is the LED of the operation button
not light up?
Does it not work after switching
to continuous operation mode?
Is the blade securely fixed?
Is the blade or blade fixture broken
or contaminated?
Is there any foreign matter attached
to the tip of the blade or the
oscillator?
Are you using the designated blade?
Before requesting A/S
Connect the adapter to the
main body.
Please contact the manufacturer
or distributor.
Press and hold the power button
for � seconds to turn on the power.
Press and hold the operation button
to work or use the continuous
operation mode.
It is in circuit protection mode.
Turn off the power, tighten or remove
the loose set screw and allow it to
cool down sufficiently before turning
on the power again.
After switching from normal to
continuous operation mode,
you need to press the operation
button once to start it
(check the handpiece LED).
Use the torque wrench to tightly
secure the blade and blade fixture
with the set screw. (Tighten it until
you hear a 'clicking' sound.)
Clean the inside of the oscillator that
goes into the blade fixture with a
cotton swab. (The blackened bottom
of the oscillator is due to friction with
the blade fixture and does not affect
performance.)
If the blade fixture is broken,
replace it with a new one.
Using a different blade may cause
product malfunction. Please use the
manufacturer's designated blade.
Solution