CUTRA CtrlAX Kullanım Kılavuzu - Sayfa 6

Kişisel Bakım Ürünleri CUTRA CtrlAX için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CUTRA CtrlAX 16 sayfaları.

Sayfayı Yazdır

�

▶ Precautions for use

Check if the blade is

properly attached to the handpiece

▶ Precautions before use

- CtrlAX cuts better than regular knives.

handpiece with care.

- Make sure the provided power adapter

is properly connected.

- Wear appropriate clothing for the job.

- Always turn oﬀ the power button and attach

the handpiece to the main body when not

using CtrlAX.

▶ Precautions when there is a beep sound

Overheating symptoms

When the temperature of the oscillator rises,

there will be a long beep sound once,

and the power will be turned oﬀ.

It will switch to a standby mode for � minutes due

to overheating. After � minutes,

there will be a long signal sound once more.

P. ��

pre-use checks and precautions

Ensure that the set screw is

tightly fastened for safety

- Secure the workpiece ﬁrmly during use.

- This product cannot be used on

metals or glass.

- Harmful gases may be generated during

cutting depending on the material being cut.

Wear a protective mask and ensure adequate

ventilation.

Overcurrent symptoms

The device will make two beep sounds

and stop its performance in the

following situations.

�. When cutting hard objects such as

metal or glass.

�. When the blade is stuck in a hard object.

�. When excessive force is applied during cutting.

Please wear safety glasses, gloves,

and other necessary protective gears

Blade non-detection symptoms

If the following situations occur,

a signal sound will be emitted� times

and the power will be turned oﬀ

�. When the blade is not attached.

�. When the set screw is not tightened properly.