Aluprof AM45-40/12-ER-P Programlama Kılavuzu - Sayfa 8

Motor Aluprof AM45-40/12-ER-P için çevrimiçi göz atın veya pdf Programlama Kılavuzu indirin. Aluprof AM45-40/12-ER-P 8 sayfaları.

14. FACTORY SETTINGS RESTORING.

Switch to programming mode

according to point 4.

Restoring to factory settings erase the limit positions and all the transmitters.The sensitivity of the obstacle detection mechanism

returns to it's default value.

In accordance with the provisions of the Directive of the European Parliament and of the Council 2012/19 / EU of 4 July 2012 on waste electrical and

electronic equipment (WEEE), it is prohibited to place of used equipment together with other wastes, marked with crossed out wheeled bin symbol.

The users are obliged to transfer their used equipment to a designated collection point for proper processing. The marking means, at the same time,

that the equipment was put on the market after 13 August 2005. These legal obligations have been introduced to reduce the amount of waste

generated from waste electrical and electronic equipment and to ensure an appropriate level of collection, recovery and recycling. The equipment

does not contain any dangerous components, which would have any particularly negative impact on the environment and human health.

PROGRAMMING MANUAL FOR AM45 MOTORS ER-P SERIES

Press the „P2" button and hold it

for 7 seconds.

The motor will make a short

move DOWN - UP.

Factory settings restored.

We reserve the right to any technical change.

Valid on 2022.01.27