Aluprof DC228 Kullanım Kılavuzu - Sayfa 2
Alıcı Aluprof DC228 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Aluprof DC228 2 sayfaları. Under plaster switch with radio receiver
Sayfayı Yazdır
1. Electrical connections between motor and under plaster swich
DC282
Power 230V / 50 Hz
2. Memorizing the first transmitter
The sequences should be done for the first and each additional transmitter which has to be programmed
Power on, next press „SET P2"
button
3. Erasing the memory
The sequences should be done for each transmitter which had to be deleted
Power on, next press „SET P2"
button
4. Mode change (with or without suport)
Power on, next press „UP" & „STOP"
buton at once for 6 seconds
" In accordance with the provisions of the Directive of the European Parliament and of the Council 2012/19 / EU of 4 July 2012 on waste
electrical and electronic equipment (WEEE), it is prohibited to place of used equipment together with other wastes, marked with crossed
out wheeled bin symbol. The users are obliged to transfer their used equipment to a designated collection point for proper processing.
The marking means, at the same time, that the equipment was put on the market after 13 August 2005.
These legal obligations have been introduced to reduce the amount of waste generated from waste electrical and electronic equipment
and to ensure an appropriate level of collection, recovery and recycling. The equipment does not contain any dangerous components,
which would have any particularly negative impact on the environment and human health."
The LED should
Press „STOP" button
blink
The LED should
Press „STOP" button
blink
The LED wil blink 3 times.
Reset done correct.
Wiring diagram
The LED is
lightining
remote controller
The LED is
Pres the „DOWN"
lightining
remote controller
OK
the operating
mode has been
changed
The LED will blink
Pres the „UP"
3 times
buton on the
The LED will blink
3 times
buton on the
OK
The transmitter
has been added
correctly
OK
The transmitter
has been deleted
correctly
2